Anycubic SP Kobra S1/S1 Combo Resistance Strain Gage Module Levelling Sensor

• The Anycubic SP Kobra S1 / S1 Combo Resistance Strain Gauge Module: is the physical contact leveling sensor and load cell bracket integrated into the printhead toolhead of the Kobra S1 series. Rather than relying on non-contact proximity or optical sensors, this module measures the minute mechanical deflection caused when the nozzle tip physically touches the build plate. This enables automatic Z-offset calculation and dynamic mesh bed leveling regardless of the bed sheet surface material (PEI, glass, textured steel).
• Direct Nozzle Bed Leveling: Detects physical contact force directly through the nozzle tip, completely eliminating manual Z-offset adjustments or offset errors caused by nozzle swaps.
• High Sensitivity Load Cell: Built into a flexible aluminum mounting bridge that reacts to micro-gram level changes in vertical pressure when probing the bed mesh matrix.
• Universal Surface Compatibility: Works across all build plate textures and coatings (textured PEI, smooth magnetic sheets, garolite) without calibration shifts.
• Pre-Wired Interface Harness: Comes integrated with high-flex lead wiring and a micro JST connector that plugs directly into the toolhead PCB board.

P040714

28078